Picture

Asger

Selvstændig

Brabrand

Indlæg: 28

PB

Programmering af signal med Intellibox

Er der nogen herinde, der kan fortælle mig, hvordan jeg programmerer en adresse på et Märklin signal (76391) med en Intellibox? Sådan trin for trin.

Fandt i mellemtiden løsningen på nettet.

Kommer her, hvis andre kan bruge den.

Programming Märklin Signals with the Intellibox (IB).

1) Turn on IB.

2) Set IB keys so that first pair corresponds to the adresses you want for the signal. Do not have a loco signal being sent to the track.

3) Make sure the desired adresses are set as Motorola, not DCC.

4) Make sure the brass clip, or a substitiute connects the contact surfaces on either side of the signal PCB.

5) Set IB to STOP.

6) Hook signal to IB.

7) Set IB to GO and after 1-2 secs to STOP.

Cool Set IB to GO [Signal should blink between 2 states].

9) Press GREEN key of first signal adress [Signal should light all leds].

10) Release GREEN key

--Next steps are only for 2-address signals 76393, 76394, otherwise go to step 17.

[Signal shoud be blinking between 2 (different) states now].

11) Press GREEN key of second signal address [Signal should light all leds].

12) Release GREEN key. [Lights go off, and on again.]

--Next steps are only for 4-address signals 76395, 76397, otherwise go to step 17. Note that the addresses you select for the 3rd and 4th button pairs must be the address you will set for the 1st and 2nd button pair for the home signal associated with this distant signal.

[Signal shoud be blinking between 2 (different) states now].

13) Press GREEN key of third signal address [Signal should light all leds].

14) Release GREEN key. [Lights go off, and on again.]

15) Press GREEN key of fourth signal address [Signal should light all leds].

16) Release GREEN key. [Lights go off, and on again.]

17 Disconnect power from signal.

18 Remove white tray or clamp between side contacts on PCB.

19 Connect signal and test it.

The white tray should be saved. It can be used again to re-program the signal. Marout Yasuo Sluijter-Borms uses a modified wire with 2 crocodile clamps. The crocodile beaks grasp the special contact surfaces on the signal PCB sides from below the plastic PCB-backplane

Mvh Asger

__________________

 Asger

Märklin · Ny bane under planlægning

Like 0 kan lide
Top

Picture

disavelo

Herning

Indlæg: 319

PB

Hvad er PCB?

Venlige hilsner

Søren

__________________

Venlige hilsner
Søren

Like 0 kan lide
Top

Picture

Gert Frikke

Indlæg: 2.323

PB

Hej!

PCB: printed circuit bord = printpladen.

Gert

__________________

modeltog - en kopi af virkeligheden på en fantasifuld måde

Like 0 kan lide
Top

Picture

disavelo

Herning

Indlæg: 319

PB

OK - tak.

Venlige hilsner

Søren

__________________

Venlige hilsner
Søren

Like 0 kan lide
Top

Kommentarvisning

Vælg din foretrukne kommentarvisning og klik på "Gem indstillinger" for at aktivere dit valg.