Update til EcoS 1 og 2 og CS 1

Hej

Hvad ligger der i opdateringen??

Christian

Hej.

Den sidste opdatering var mere brugbar for mit vedkommene. Der kan man til at kunne styre pendul tog og redigere tog selv når du har multi tog fremme på skærmen. Den nye indeholder det her.

New features:

- For enabling routes, you can now use Railcom feedback and locomotive categories.
  Up to 16 categories available. Editing of categorie names via new setup2. To each
  locomotive, you can assign up to 4 categories. When entering conditions for route control,
  you can now select up to 3 "locomotive categories", that needs to be true before the route
  will be enabled. These conditions are tested for "contains", if the locomotive ID (address)
  is detected via RailCom feedback and at least one of the locomotive conditions contains this
  address.
  If no address is detected using the RailCom feedback system, or the address is not assigned to
  any locomotive categorie, the condtion is is false.

- Conditions for routes now can be "non-triggering". This means that when these conditions change,
  they can no longer trigger a route, but the state of this condition will be tested when the other
  (triggering) conditions are checked.

- In the power monitor, a booster that caused a short circuit is now displayed. This helps for
  debugging your layout.

- New decoder profiles for LokSound V4.0 M4, LokSound XL V4.0 and improvements of existing decoder
  profiles

Bugfixes and cosmetic changes:

- sometimes, users reported that routes sometimes did trigger by mistake during the powerup
  sequence of the ECoS. Now, you can delay the route triggering during startup. This can be
  selected in setup 2, "startmode and loco-categorie" by selecting "Lock routes on startup"
  Needs setting "Track on at startup" to be enabled, too.
- Setting the power limit for external boosters sometimes did not work.
- Fixed some small display problems with RailComPlus symbol during automatic detection.
- If you read in a decoder using decoder profiles, the protocol is no longer automatically
  changed to DCC28/14.
- when changing decoder profile or decoder type, the function button assignment was changed
  sometimes in error.